29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 2 :
Ligne 2 : + + + + + + − Voici xxx.+ + + + +
aucun résumé de modification
[[Fichier:ADF-WaveShield-Presentation.jpg|center|Détail des éléments]]
[[Fichier:ADF-WaveShield-Presentation.jpg|center|Détail des éléments]]
# a
# b
# c
# d
# e
# f
Adding quality audio to an electronic project is surprisingly difficult. People tend to end up either using low-quality ISD chips (you might get 8Khz sampling rate for 30seconds out of these, if you're lucky!) or mucking around with trying to control a CD or MP3 player. Although it's possible to generate audio direct from a microcontroller using a PWM output, the quality is often low and its hard to fit a lot of music in an EEPROM chip. You can buy an embedded MP3 player board, but they're either expensive or difficult to use!
Here is a shield for Arduino that solves many of these problems. It can play up to 22KHz, 12bit uncompressed audio files of any length. It's low cost, available as an easy-to-make kit. It has an onboard DAC, filter and op-amp for high quality output. Audio files are read off of an SD/MMC card, which are available at nearly any store. Volume can be controlled with the onboard thumbwheel potentiometer.
Source: [http://www.ladyada.net/make/waveshield/index.html|ici]
{{ADF-Accord}}
{{ADF-Accord}}
{{MCH-Accord}}
{{MCH-Accord}}