Différences entre versions de « Rasp-Hack-LED »

De MCHobby - Wiki
Sauter à la navigation Sauter à la recherche
Ligne 11 : Ligne 11 :
 
Place the cobbler onto the board board straddling the center line. Connect the GND pin (ground) to the blue power rail on the side of the breadboard. You'll need two resistors (any values from 100 ohm up to 1000 ohm are fine). One end of the resistors connects to the cobbler row marked #18 and then the other side connects to a row that isn't used by the cobbler. The other resistor connects to the cobbler row marked #23 and the other end to another empty row.
 
Place the cobbler onto the board board straddling the center line. Connect the GND pin (ground) to the blue power rail on the side of the breadboard. You'll need two resistors (any values from 100 ohm up to 1000 ohm are fine). One end of the resistors connects to the cobbler row marked #18 and then the other side connects to a row that isn't used by the cobbler. The other resistor connects to the cobbler row marked #23 and the other end to another empty row.
  
[[Fichier:Rasp-Hack-LED-Res.jpg]]
+
[[Fichier:Rasp-Hack-LED-Res.jpg|400px]]
  
 
== Ou Acheter ==
 
== Ou Acheter ==

Version du 21 octobre 2012 à 09:31

Introduction

Ce tutoriel vous explique comment exploiter comment commander des LEDs (DELs) en utilisant un [PI-Cobbler] et Python. Assurez-vous d'avoir [mis votre environnement Python à jour].

PI Cobbler & resistances

Lorsque vous raccordez le câble GPIO, assurez vous de faire correspondre le fil rouge avec le broche P1 du GPIO du Raspberry (du côté de la carte SD). Le fil rouge, c'est la pin/broche #1 du câble.

L'autre côté du câble ne peut s'insérer que d'une seule façon sur le cobbler car il y a un détrompeur.

xxx Place the cobbler onto the board board straddling the center line. Connect the GND pin (ground) to the blue power rail on the side of the breadboard. You'll need two resistors (any values from 100 ohm up to 1000 ohm are fine). One end of the resistors connects to the cobbler row marked #18 and then the other side connects to a row that isn't used by the cobbler. The other resistor connects to the cobbler row marked #23 and the other end to another empty row.

Rasp-Hack-LED-Res.jpg

Ou Acheter

Le Pi-Cobbler est disponible de stock chez MCHobby.

Toute référence, mention ou extrait de cette traduction doit être explicitement accompagné du texte suivant : «  Traduction par MCHobby (www.MCHobby.be) - Vente de kit et composants » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.

L'utilisation commercial de la traduction (texte) et/ou réalisation, même partielle, pourrait être soumis à redevance. Dans tous les cas de figures, vous devez également obtenir l'accord du(des) détenteur initial des droits. Celui de MC Hobby s'arrêtant au travail de traduction proprement dit.

Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com