Mydin-Class-Pico3Mod - Historique des versions

Admin : /* Examples */

2025-04-29T16:14:37Z

Examples

2025-04-29T11:46:35Z

Board schematic

2025-04-29T11:12:16Z

Class Header

2025-04-29T11:08:39Z

was_pressed(): bool

2025-04-29T11:04:05Z

before_run(): bool

2025-04-29T11:02:43Z

task_setup(): bool

2025-04-29T00:16:13Z

2025-04-29T00:15:54Z

before_run(): bool

2025-04-29T00:11:18Z

task_setup(): bool

2025-04-29T00:05:17Z

was_pressed(): bool

@@ Ligne 29 : / Ligne 29 : @@
 === Examples ===
-The micropython-mydin repository contains many useful examples.
+The [https://github.com/mchobby/micropython-mydin/tree/main/examples/din_controlers micropython-mydin repository] contains many useful examples.
 == Class Header ==

← Version précédente		Version du 29 avril 2025 à 11:46
Ligne 25 :		Ligne 25 :

	[[Fichier:Mydin-Class-Pico3Mod-schematic-03.png]]		[[Fichier:Mydin-Class-Pico3Mod-schematic-03.png]]
		+
		+
		+	=== Examples ===
		+
		+	The micropython-mydin repository contains many useful examples.

	== Class Header ==		== Class Header ==

@@ Ligne 28 : / Ligne 28 : @@
 == Class Header ==
-{{prop|Ancestor| PicoControler }}
+{{prop|Ancestor| [[Mydin-classes-diagram#PicoControler|PicoControler]] }}
 {{prop|Class | '''Pico3Mod'''}}
 {{prop|Module | pico }}

@@ Ligne 137 : / Ligne 137 : @@
 ==== was_pressed(): bool ====
-Check if a given button has been pressed since the last check. It also resets the pressed state for that given button.
+Check if a given button has been pressed since the last check. This method also resets the pressed state for the requested button.
 {{underline|Reminder:}} the button state change is capture by IRQ event handler.

@@ Ligne 159 : / Ligne 159 : @@
 ==== before_run(): bool ====
-Check if the internal MCU temperature is in over-temperature before allowing the {{fname|run()}} to starts the ''userloop''.
+The overriden {{fname|before_run()}} checks if the internal MCU temperature is in over-temperature state before allowing the {{fname|run()}} to starts the ''userloop''.
 That would avoids the DIN software to restart in bad conditions if the MCU have been reset for over-temperature reason.

@@ Ligne 149 : / Ligne 149 : @@
 ==== task_setup(): bool ====
-The overriden task_setup() is used to append the following tasks:
+The overriden task_setup() is '''adds the following tasks''':
-# The __coro_ds18b20 task to read the temperature sensor every 10 seconds (if has_ds18b20==True) and store the value.
+# The '''__coro_ds18b20 task''' to read the temperature sensor every 10 seconds (if has_ds18b20==True) and store the value.
-# The __coro_monitor task to check the internal MCU temperature every 60 seconds. Over-temperature will reset the microcontroler.
+# The '''__coro_monitor task''' to check the internal MCU temperature every 60 seconds. Over-temperature will reset the microcontroler.
 <syntaxhighlight lang="python">