Retournez l'afficheur PiTFT 2.8" et localisez la pastille portant le '''libellé #18'''. Nous aurons besoin de couper la trace afin de pouvoir utiliser le GPIO 18 pour le PiGrrl (Le bouton Y est raccordé sur cette broche).
−
{{ADFImage|Rasp-PiGRRL-2-PiTFT-01.jpg|640px}}
−
Flip the 2.8" PiTFT display over and locate the pad with '''label #18. '''We need to cut this trace in order to properly use GPIO 18 (The Y Button is wired to this GPIO). By default, when GPIO 18 is triggered to ground, it will disable the LED backlighting on the display - Cutting the trace here will disable that feature.
+
Par défaut, le rétro-éclairage de l'écran est désactivé lorsque le GPIO 18 est placé à la masse - couper la trace permet de désactiver cette fonctionnalité.
−
== Cut Trace #18 ==
+
== Couper la trace du GPIO #18 ==
{{ADFImage|Rasp-PiGRRL-2-PiTFT-02.jpg|640px}}
{{ADFImage|Rasp-PiGRRL-2-PiTFT-02.jpg|640px}}
−
Use a hobby knife to mark in between the two pads and make sure it is deep enough to fullly break the trace.
+
Utilisez un cutter pour sectionner la trace entre les deux partie... il faut sectionner suffisamment profondément pour complètement couper la section de cuivre.
−
−
That's pretty much all we need to do to the PiTFT display!
−
+
C'est tout ce qui doit être fait avec l'afficheur PiTFT!