Ligne 1 : |
Ligne 1 : |
| {{Rasp-PiGRRL-2-NAV}} | | {{Rasp-PiGRRL-2-NAV}} |
− |
| |
− | {{traduction}}
| |
| | | |
| == Introduction == | | == Introduction == |
Ligne 15 : |
Ligne 13 : |
| Coupez deux section de 10cm de fil 30AWG. Dénudez les et étamez chaque bout. | | Coupez deux section de 10cm de fil 30AWG. Dénudez les et étamez chaque bout. |
| | | |
− | == Prep Raspberry Pi Audio Pins == | + | == Preparer les broche audio du Raspberry Pi == |
| Retournez la carte du Raspberry-Pi 2 et localisez les 3 broches sous le connecteur Audio Jack. | | Retournez la carte du Raspberry-Pi 2 et localisez les 3 broches sous le connecteur Audio Jack. |
| | | |
Ligne 35 : |
Ligne 33 : |
| {{ADFImage|Rasp-PiGRRL-2-Sortie-Audio-03.jpg|640px}} | | {{ADFImage|Rasp-PiGRRL-2-Sortie-Audio-03.jpg|640px}} |
| | | |
− | == Connect Wires to Amp == | + | == Connectez les fils sur l'ampli == |
− | Solder the negative (blue) wire to the A– pin on the amp, and the positive (red) wire to the A+ pin on the amp.
| + | Soudez: |
| + | * Le fil bleu (négatif) sur la broche A– de l'ammplificateur. |
| + | * Le fil rouge (positif) sur la broche A+ . |
| | | |
| {{ADFImage|Rasp-PiGRRL-2-Sortie-Audio-04.jpg|640px}} | | {{ADFImage|Rasp-PiGRRL-2-Sortie-Audio-04.jpg|640px}} |
− |
| |
− | {{traduction}}
| |
− | No class registered in CONVERSION_CLASS for section build-alert alert-danger
| |
− | <nowiki>
| |
− | <div class="alert">
| |
− | <i class='fa fa-exclamation-circle'></i>
| |
− | Audio Connection Confusion? You may notice the audio connections in the photo above are reserved. This photo is intended for the Pi 1 Model B+ (not the 2 or 3). Be sure to follow the first set of photos if you're using the Pi 2 or 3. If your using the Pi 1 Model B+, then reference the photo above.
| |
− | </nowiki>
| |
| | | |
| {{Rasp-PiGRRL-2-TRAILER}} | | {{Rasp-PiGRRL-2-TRAILER}} |