should turn the LED on then off again. If not, check that its wired up correctly – that the LED is the right way round and that the MCP23017 appears as address 0×20 in the output of the '''gpio i2cd''' command. (If it’s something other than 0×20 then substitute that for the 0×20 in the command above).
+
Vérifiez le cablage si cela ne fonctionne pas correctement, que la LED est raccordée dans le bon sens, que le MCP23017 apparait sous l'adresse 0×20 dans le résultat de la commande '''gpio i2cd'''. (Si le résultat est différent de 0x20 alors substituez 0x20 par cette cette autre valeur dans les commandes ci-dessus).