Ligne 1 : |
Ligne 1 : |
| {{ADF-ADJ-BBALIM-NAV}} | | {{ADF-ADJ-BBALIM-NAV}} |
| + | = Comment utiliser = |
| | | |
− | Blba
| + | Ce kit est vraiment simple d'emploi. Vous devez d'abord assembler le kit, vérifiez les instructions d'assemblage pour savoir comment le souder! |
| + | |
| + | = L'entrée à main droite = |
| + | L'étage haute tension ('input' en anglais) se trouve à main droite. |
| + | |
| + | Il y a deux sorties ("outputs" en anglais) sur la carte. A main droite, il y a l'étage haute tension. C'est la tension qui vient directement de la prise Jack (ou du bornier). |
| + | |
| + | Il y a une diode pour prévenir la mise sous tension négative et protéger le régulateur... même si cela occasionne une chute de tension d'environ 200mv. |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-01.jpg]] |
| + | |
| + | For example, this photo is me testing the output of the right hand side with a 12VDC regulated power adapter attached. The voltage is within 200mV of 12V. The green LED indicates that there is power on the right hand side. |
| + | |
| + | = Left hand 'output' = |
| + | |
| + | The left hand side is the 'regulated' voltage side. This is the power that is running through the voltage regulator. This voltage is adjustable |
| + | |
| + | If you select 3.3v on the voltage selection switch you will be able to measure that output voltage. The red indicator LED will be somewhat dim |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-02.jpg]] |
| + | |
| + | Then you can also select '''5V''' to generate a regulated 5V supply |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-03.jpg]] |
| + | |
| + | Finally, by selecting '''Adj'''. you can adjust the supply to anything you want from as low as ~1.3V to within half a volt of the input (which can be as high as 20V) |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-04.jpg]] |
| + | |
| + | Once you set the pot, the output voltage is not dependent on the input voltage. That is, if you dial in 6V and you switch from a 9V to 12V supply, the output will stay at 6V. |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-05.jpg]] |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-06.jpg]] |
| + | |
| + | = Le dissipateur de chaleur = |
| + | |
| + | SI votre alimentation s'interrompt constamment ou si elle est très chaude ALORS vous avez besoin d'un dissipateur de chaleur! |
| + | |
| + | Vous pouvez simplement le glisser sur le régulateur. |
| + | |
| + | [[Fichier:ADF-ADJ-BBALIM-USE-07.jpg]] |
| | | |
| {{ADF-Accord}} | | {{ADF-Accord}} |
| | | |
| {{MCH-Accord}} | | {{MCH-Accord}} |