Modifications

Sauter à la navigation Sauter à la recherche
1 721 octets ajoutés ,  8 février 2017 à 07:23
Page créée avec « {{RASP-FT232H-NAV}} {{traduction}} == Port série/UART == Out of the box the FT232H is configured to act just like an {{pl|77|convertisseur FTDI (USB vers Série)}}. Th... »
{{RASP-FT232H-NAV}}

{{traduction}}

== Port série/UART ==
Out of the box the FT232H is configured to act just like an {{pl|77|convertisseur FTDI (USB vers Série)}}. This is great for talking to a serial device like an Arduino from your computer. It's safe to use with both 3.3 volt and 5 volt signals. This means the FT232H breakout can used to safely talk to an Arduino's 5 volt serial ports, and a Raspberry Pi or BeagleBone Black's 3.3 volt serial ports!

When used as a serial UART the FT232H breakout pins have the following serial functions:

* '''D0 - TX''' or transmit pin. This pin is the serial data output by the FT232H chip and should be connected to the RX or receive pin of a serial device.
* '''D1 - RX''' or receive pin. This pin is the serial data input for the FT232H chip and should be connected to the TX or transmist pin of a serial device.
* '''D2 - RTS''' or ready to send pin. This is an optional pin for flow control of serial connections.
* '''D3 - CTS''' or clear to send pin. Like RTS, this is an optional pin for flow control.
* '''D4 - DTR''' or data terminal ready pin. Another optional pin for flow control in RS-232 serial connections.
* '''D5 - DSR''' or data set ready pin. Like DTR, this is another optional pin for flow control in RS-232 serial connections.
* '''D6 - DCD''' or data carrier detect pin. This is an optional pin that is sometimes used in RS-232 serial communication.

The most important and commonly used serial pins are '''D0''' and '''D1''' for the '''TX''' and '''RX''' pins. The other pins are only necessary if you're using a device with flow control or specific RS-232 serial needs.

== Pilotes USB Série ==
{{traduction}}


{{RASP-FT232H-TRAILER}}
32 920

modifications

Menu de navigation