32 908
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 10 :
Ligne 10 : + + + + + + + + + + + + + + + + + + + + + + +
ENG-CANSAT-PICO-MISSION1-CAPTURE (voir la source)
Version du 31 juillet 2025 à 21:18
, 31 juillet 2025 à 21:18→Wiring on a Pico
* Air pressure
* Air pressure
and transmitting the information via the RFM69HCW radio module.
and transmitting the information via the RFM69HCW radio module.
== With Cansat Kit V2 ==
The CANSAT-BASE board of {{pl|2824|Kit Cansat Kit V2}} does already contains power regulation and the radio circuitry.
=== Wire the barometric sensor ===
The CANSAT-BASE does already fits a StemmaQt/Qwiic connector. Just connect the Qwiic/StemmaQt wires between the board and the sensor.
The BMP280 is wired to the Pico via the Qwiic connector, so it is connected to the {{fname|I2C(0)}} bus.
[[Fichier:ENG-CANSAT-V2-BMP280-QWIIC-01.jpg|480px]]
=== Wire the temperature sensor ===
Then connect the TMP36 analog sensor as follows:
* The pin 1 (on the left) to a power source (3.3V),
* The pin 3 (the the right) to the ground/GND.
* The pin 2 (middle one) to the ADC0 (GP26) analog input.
The breakout line can be used to solder the temperature sensor, the Analog Grove connector can also be used for quick connection on the board.
[[Fichier:ENG-CANSAT-V2-TMP36-ON-BREAKOUT-10.jpg|560px]]
[[Fichier:ENG-CANSAT-V2-TMP36-ON-ANALOG-GROVE-10.jpg|560px]]
== Wiring on a Pico ==
== Wiring on a Pico ==