Ligne 1 : |
Ligne 1 : |
| {{LOLShield-Nav}} | | {{LOLShield-Nav}} |
| | | |
− | x
| + | == Quelques recommandations avant de commencer == |
| + | * Lay out everything beforehand, and go through the directions at least once before you start. |
| + | * Keep your iron tip clean. I Highly recommend a brass tip cleaner. |
| + | * Use 60/40 flux core electrical solder, unless you have a good iron and know what you are doing. |
| + | * The joints should look like a “Hershey’s Kiss”, completely covering the pad. |
| + | * Do not over-heat things. It will only take 1-3 seconds at the most to solder a joint. |
| + | * Don’t abuse your tools. Use your tools for their intended purpose, and keep them maintained. This will dramatically improve the quality of anything you do. |
| + | * Double check your work. |
| + | |
| + | == Liste des pièces == |
| + | |
| + | [[Fichier:ADF-LOLShield-Content.jpg]] |
| + | |
| + | Le kit contient les éléments suivants |
| + | * 1 carte PCB du LoL Shield (v1.5) |
| + | * 133 Leds (rouge, verte, blanche, etc en fonction du shield acheté). |
| + | * 1 pin header de 36 éléments. |
| | | |
| {{MCH-Accord}} | | {{MCH-Accord}} |