Ligne 15 : |
Ligne 15 : |
| | | |
| === Le code === | | === Le code === |
− | Pour commencer, charger un sketch 'blank" dans votre Arduino: | + | Pour commencer, charger un sketch "blanc" dans votre Arduino: |
| | | |
− | <nowiki>// this sketch will allow you to bypass the Atmega chip | + | <nowiki>// Ce sketch vous permet de by-passer l'Atmega |
− | // and connect the fingerprint sensor directly to the USB/Serial | + | // et de connecter des senseurs (comme un GPS ou lecteur d'empreinte) |
− | // chip converter. | + | // directement sur le convertisseur USB/Série de votre carte |
| + | // Arduino. |
| | | |
− | // Connect VIN to +5V | + | // Connecter VIN au +5V |
− | // Connect GND to Ground | + | // Connecter GND à la masse/ground |
− | // Connect GPS RX (data into GPS) to Digital 0 | + | // Connecter GPS RX (réception donnée dans le GPS) vers Arduino Pin 0 (digitiale) |
− | // Connect GPS TX (data out from GPS) to Digital 1 | + | // Connecter GPS TX (sortie de donnée du GPS) vers Arduino Pin 1 (digitiale) |
| | | |
| void setup() {} | | void setup() {} |
| void loop() {} | | void loop() {} |
| </nowiki> | | </nowiki> |
− | This is will free up the converter so you can directly wire and bypass the Arduino chip. Once you've uploaded this sketch, wire the GPS as follows: | + | This is will free up the converter so you can directly wire and bypass the Arduino chip. Once you've uploaded this sketch, wire the GPS as follows: |
| | | |
| === Le montage === | | === Le montage === |