29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 21 :
Ligne 21 : − +
Arduino Wireless Shield XBee 802.15.4 (voir la source)
Version du 25 décembre 2012 à 19:48
, 25 décembre 2012 à 19:48→Un exemple simple
Serial.print('L');
Serial.print('L');
delay(1000);
delay(1000);
}</nowkiki>
}</nowiki>
When it's finished uploading, you can check that it's working with the Arduino serial monitor. You should see H's and L's arriving one a second. Turn off the serial monitor and unplug the board. Change the switch to the Micro setting. Now connect both boards to power. After a few seconds, you should see the LED on the first board turn on and off, once a second. (This is the LED on the Arduino board itself, not the one on the Xbee shield, which conveys information about the state of the Xbee module.) If so, congratulations, your Arduino boards are communicating wirelessly.
When it's finished uploading, you can check that it's working with the Arduino serial monitor. You should see H's and L's arriving one a second. Turn off the serial monitor and unplug the board. Change the switch to the Micro setting. Now connect both boards to power. After a few seconds, you should see the LED on the first board turn on and off, once a second. (This is the LED on the Arduino board itself, not the one on the Xbee shield, which conveys information about the state of the Xbee module.) If so, congratulations, your Arduino boards are communicating wirelessly.