Modifications

== Reset des processeurs (AR9331, WiFi et 32U4)==

== Reset des processeurs (AR9331, WiFi et 32U4)==

To restart the AR9331, which reboots Linino, press the "YÚN RST" reset button that is close to the analog inputs pins and the LEDs of the board.

Pour redémarrer la processeur AR9331, qui redémarre Linino, presser le bouton reset "YÚN RST" qui se trouve à côté des entrées analogiques et des LEDs (sur la carte).

To restart the the 32U4 and restart the currently installed Arduino sketch, tap the button next to the Ethernet port ''two times''.

Pour redémarrer le 32U4 et redémarrer votre sketch/croquis Arduino, pressez le bouton à côté du port Ethernet ''deux fois''.

The reset button for WiFi is located next to the USB-A connector. When you press the button, the WLAN LED will flash.

Le bouton reset du WiFi se trouve près du connecteur USB-A. Lorsque vous pressez ce bouton, la LED WLAN commence à clignoter.

If you move to a different network and can no longer wirelessly access the Yún through its web interface, you can reset the Yún's network configuration by pressing the Wifi reset button for longer longer than 5 seconds, but less than 30, the AR9331 processor will reboot. The WiFi configuration will be reset and the Yún will start its own wiFi network Arduino Yún-XXXXXXXXXXXX. Any other modification/configuration will be retained.

Si vous passez sur un réseau différent et que vous ne pouvez plus accéder à votre Yún par l'intermédiaire de sont interface Web, vous pouvez faire une réinitialisation (''reset'') de la configuration  you can reset the Yún's network configuration by pressing the Wifi reset button for longer longer than 5 seconds, but less than 30, the AR9331 processor will reboot. The WiFi configuration will be reset and the Yún will start its own wiFi network Arduino Yún-XXXXXXXXXXXX. Any other modification/configuration will be retained.

To reset the Linino distribution to its default state, press the WiFi reset button for at least 30 seconds. The board reverts to the original settings as if it had been reflashed or taken out of the box. Among other things, this removes all installed files and network settings.  

To reset the Linino distribution to its default state, press the WiFi reset button for at least 30 seconds. The board reverts to the original settings as if it had been reflashed or taken out of the box. Among other things, this removes all installed files and network settings.

== Serial re-enumeration on reset ==

== Serial re-enumeration on reset ==