Ligne 1 : |
Ligne 1 : |
| {{Bluefruit-LE-Shield-NAV}} | | {{Bluefruit-LE-Shield-NAV}} |
− | {{traduction}}
| + | |
| == Commandes matériel == | | == Commandes matériel == |
| Les commandes suivantes vous permettent d'interagir avec la bas niveau matériel du module Bluefruit LE. Vous pourrez lire et modifier l'état des GPIO, effectuer une conversion Analogique-vers-digital (ADC), etc. | | Les commandes suivantes vous permettent d'interagir avec la bas niveau matériel du module Bluefruit LE. Vous pourrez lire et modifier l'état des GPIO, effectuer une conversion Analogique-vers-digital (ADC), etc. |
Ligne 189 : |
Ligne 189 : |
| | | |
| == AT+UARTFLOW == | | == AT+UARTFLOW == |
− | Enables or disable hardware flow control (CTS + RTS) on the UART peripheral block of the nRF51822.
| + | Active ou désactive le contrôle de flux matériel (CTS + RTS) pour le port série/UART sur le nRF51822. |
| | | |
| * Codebase Revision: 0.7.0 | | * Codebase Revision: 0.7.0 |
− | * Paramètres: HW flow control state, which can be one of: | + | * Paramètres: Etat du contrôle de flux matériel. Peut prendre l'une des valeurs suivantes: |
− | ** on | + | ** '''on''' ou '''1''' - activer |
− | ** off | + | ** '''off''' ou '''0''' - désactiver |
− | ** 0
| + | * Sortie: Si la commande est exécutée sans paramètre, elle retour un nombre 0 ou 1 indiquant si le contrôle de flux est activé (1) ou désactivé (0). |
− | ** 1
| |
− | * Sortie: If run with no Paramètres, returns a number representing whether flow control is enabled (1) or disabled (0). | |
| | | |
− | <nowiki># Check the current flow control state | + | <nowiki># Vérifie l'état du contrôle de flux |
| AT+UARTFLOW | | AT+UARTFLOW |
| 1 | | 1 |
| OK | | OK |
| | | |
− | # Disable HW flow control | + | # Désactive le contrôle de flux matériel |
| AT+UARTFLOW=off | | AT+UARTFLOW=off |
| OK</nowiki> | | OK</nowiki> |
| | | |
| {{Bluefruit-LE-Shield-TRAILER}} | | {{Bluefruit-LE-Shield-TRAILER}} |