29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 14 :
Ligne 14 : + + + + + + + + + + + + + + + +
→Ouvrir le croquis
{{ADFImage|Bluefruit-LE-Shield-UriBeacon-01.png}}
{{ADFImage|Bluefruit-LE-Shield-UriBeacon-01.png}}
== Configuration ==
Check the '''Configuration!''' page earlier to set up the sketch for Software/Hardware UART or Software/Hardware SPI. The default is hardware SPI
If using software or hardware Serial UART:
* This tutorial does not need to use the MODE pin, '''make sure you have the mode switch in CMD mode''' if you do not configure & connect a MODE pin
* Don't forget to also '''connect the CTS pin on the Bluefruit to ground if you are not using it!''' (The Flora has this already done)
== Exécuter le croquis ==
Once you upload the sketch to your board (via the arrow-shaped upload icon), and the upload process has finished, open up the Serial Monitor via '''Tools > Serial Monitor''', and make sure that the baud rate in the lower right-hand corner is set to '''115200''':
{{ADFImage|Bluefruit-LE-Shield-UriBeacon-10.png}}
At this point you can open the Physical Web Application for [https://play.google.com/store/apps/details?id=physical_web.org.physicalweb Android] or for [https://itunes.apple.com/us/app/physical-web/id927653608?mt=8 iOS], and you should see a link advertising Adafruit's website:
{{ADFImage|Bluefruit-LE-Shield-UriBeacon-20.jpg}}
{{Bluefruit-LE-Shield-TRAILER}}
{{Bluefruit-LE-Shield-TRAILER}}