29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 95 :
Ligne 95 : − + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→PowerBoost 1000 Charger Soldering
== PowerBoost 1000 Charger Soldering ==
== PowerBoost 1000 Charger Soldering ==
The PowerBoost 500 of the kit can be replaced with a PowerBoost 1000 to get more power (1000mA) from the Lipo battery
The PowerBoost 500 of the kit can be replaced with a '''PowerBoost 1000 to get more power''' (1000mA) from the Lipo battery
{{traduction}}
{{traduction}}
{{ambox-stop|text=The instructions doesn't applies to the PowerBoost 500 charger.}}
[[fichier:ENG-CANSAT-PICO-03.jpg|360px]]
Let's solder it
{{asm-begin}}
{{asm-row|img=ENG-CANSAT-PICO-20.jpg}}
{{asm-text}} Pico up the base board with the back of the board on the desk.
You should see Qwiic connector and the text "PowerBoost 500 Charger" written.
{{asm-row|img=ENG-CANSAT-PICO-30.jpg}}
{{asm-text}} Prepare a section of 8 Pins and remove 2 of the pins as showned on the picture.
{{asm-row|img=ENG-CANSAT-PICO-31.jpg}}
{{asm-text}} Place the modified pin Header into the connector (the short part into the connector).
{{underline|Tip:}} use a small piece a paper tape to maintain the connector right in place.
{{asm-row|img=ENG-CANSAT-PICO-22.jpg}}
{{asm-text}} Flip over the board and solder the connector in place.
{{asm-row|img=ENG-CANSAT-PICO-33.jpg}}
{{asm-text}} Flip the board again (to see the "PowerBoost" text).
Slides the PowerBoost 1000 breakout on the connector and Solder the pins (except the 2 missing ones).
'''WARNING: back of the breakout board MUST be visible (not the components)!'''
{{underline|Tip:}}
{{traduction}}
* Push on the PowerBoost breakout with the nail against the connector.<br />This will flatten the breakout on the connector (and make it paralleled to the base board).
* Charge the tip of the iron with some solder.
* Tack a drop of solder a pin to make the breakout staying right in place (no need to be perfect right now)
* Solder the other pins of the breakout
* Now solder the initial tacked pin (to have a nice & great solder join on that pin too)
{{asm-end}}
== RFM69HCW Soldering ==
== RFM69HCW Soldering ==