29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 58 :
Ligne 58 : + + + + + + + + + + + + + + + + + + + + + +
ENG-CANSAT-PICO-MISSION1-CAPTURE (voir la source)
Version du 6 mars 2022 à 00:43
, 6 mars 2022 à 00:43→Wiring on a Pico
| 3V3
| 3V3
|}
|}
== Wiring on Kit Cansat for Pico ==
=== Wire the barometric sensor ===
The BMP280 is wired to the Pico (I2C bus) via the Qwiic connector
xxx
=== Wire the temperature sensor ===
Then connect the TMP36 sensor as follows:
* The pin 1 (on the left) to a power source (3.3V),
* The pin 3 (the the right) to the ground/GND.
* The pin 2 (middle one) to the ADC0 analog input.
The Pico pad on the board are large enough to quickly solder the TMP36 on the board. The TMP36 can also bee soldered under the board.
[[Fichier:ENG-CANSAT-PICO-TMP36-10.png|320px]]
=== Wire the radio module ===
Finally wire the RFM69HCW radio as follows:
{{ENG-CANSAT-PICO-TRAILER}}
{{ENG-CANSAT-PICO-TRAILER}}