29 837
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 41 :
Ligne 41 : − +
→Power Pins
* '''GND''': Common ground between logic and power.
* '''GND''': Common ground between logic and power.
* '''Vin''': Power In 3.3 to 6V. The board regulated it to 3.3V. '''Be sure you can supply up to 150mA''' on this pin since Radio Emitting can reach this current level.
* '''Vin''': Power In 3.3 to 6V. The board regulated it to 3.3V. '''Be sure you can supply up to 150mA''' on this pin since Radio Emitting can reach this current level.
* '''EN''': Enbable Pin used to switch off the Power supply (and the radio module). EN use a pull-up resistor to maintain the regulator enabled, just pull it down to switch off the radio.
* '''EN''': Enbable Pin used to switch off the Power supply (and the radio module). EN pin use a pull-up resistor to maintain the regulator enabled, just set it to LOW to switch off the radio.
== SPI Interface Pins ==
== SPI Interface Pins ==