29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 24 :
Ligne 24 : − +
FEATHER-M0-MicroPython-REPL (voir la source)
Version du 13 décembre 2017 à 20:53
, 13 décembre 2017 à 20:53→Install Serial Port Terminal Software
'''On Windows''' you'll want to use a tool like [http://www.chiark.greenend.org.uk/~sgtatham/putty/ PuTTY] to connect to the serial port. Download and run PuTTY, then configure it to use a serial connection to the board's COM port at 115200 baud similar to as shown below:
'''On Windows''' you'll want to use a tool like [http://www.chiark.greenend.org.uk/~sgtatham/putty/ PuTTY] to connect to the serial port. Download and run PuTTY, then configure it to use a serial connection to the board's COM port at 115200 baud similar to as shown below:
{{ADFImage|FEATHER-M0-MicroPython-REPL-02.png|640px}}
{{ADFImage|FEATHER-M0-MicroPython-REPL-02.png}}
After clicking '''Open''' you should see a new window pop up with the current output from the running code. If no code is running, it may be blank so hit '''Ctrl - C''' to get to the REPL prompt.
After clicking '''Open''' you should see a new window pop up with the current output from the running code. If no code is running, it may be blank so hit '''Ctrl - C''' to get to the REPL prompt.