29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 92 :
Ligne 92 : − + − + + + + + +
→Getting Started
== Getting Started ==
== Getting Started ==
[[File:GSM-Shield-03.jpg|frame|center]]
[[File:GSM-Shield-03-fr.jpg|frame|center]]
<center>'''Easy steps to get your GPRS Shield started'''</center>
<center>'''Les quelques étapes pour démarrer avec votre Shield GPRS'''</center>
Note:
Si vous utilisez votre Monitor Arduino pour tester votre shield (avec le sketch proposé plus loin), n'oubliez pas de configurer votre connexion en 19200 bauds et Carriage Return.
=== AT Command syntax ===
=== AT Command syntax ===
AT Command is simple textual commands communicated with GPRS Shield over its serial interface (UART). The "AT" or "at" prefix must be set at the beginning of each Command line. To terminate a Command line enter <CR>. Commands are usually followed by a response that includes. "<CR><LF><response><CR><LF>" Throughout this document, only the responses are presented, <CR><LF> are omitted intentionally.
AT Command is simple textual commands communicated with GPRS Shield over its serial interface (UART). The "AT" or "at" prefix must be set at the beginning of each Command line. To terminate a Command line enter <CR>. Commands are usually followed by a response that includes. "<CR><LF><response><CR><LF>" Throughout this document, only the responses are presented, <CR><LF> are omitted intentionally.