29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 42 :
Ligne 42 : + + + + +
→Vitesse et Micro-stepping
| align="left" | Heighth-step (huitième de pas, 1/8)
| align="left" | Heighth-step (huitième de pas, 1/8)
|}
|}
== Entrées de contrôle ==
Each pulse to the STEP input corresponds to one microstep of the stepper motor in the direction selected by the DIR pin. These inputs are both pulled low by default through internal 500 kΩ pull-down resistors. If you just want rotation in a single direction, you can leave DIR disconnected.
The chip has two different inputs for controlling its power states: {{overline|SLEEP}} and {{overline|ENBL}} {{underline|x}}. For details about these power states, see the datasheet. Please note that the driver pulls both of these pins low through internal 500 kΩ pull-down resistors. The default SLEEP state prevents the driver from operating; this pin must be high to enable the driver (it can be connected directly to a logic “high” voltage between 2.5 V and 5 V, or it can be dynamically controlled by connecting it to a digital output of an MCU). The default state of the ENBL pin is to enable the driver, so this pin can be left disconnected.
== Où Acheter ==
== Où Acheter ==