Modifications

{{ADFImage|NeoPixel-UserGuide-Bonnes-Pratiques-01.jpg|640px}}

{{ADFImage|NeoPixel-UserGuide-Bonnes-Pratiques-01.jpg|640px}}

* Before connecting NeoPixels to any power source, add a large capacitor (1000 µF, 6.3V or higher) across the + and – terminals as shown above.

* Avant de connecter des NéoPixels sur n'importe quelle alimentation, pensez à ajouter une grosse capacité (1000 µF, 6.3V ou plus) entre les broches + et  – comme sur l'image ci-dessus.

* Place a 300 to 500 Ohm resistor between the Arduino data output pin and the input to the first NeoPixel. This resistor must be at the NeoPixel end of the wire to be effective! Some products already incorporate this resistor…if you’re not sure, add one…there’s no harm in doubling up!

* Place a 300 to 500 Ohm resistor between the Arduino data output pin and the input to the first NeoPixel. This resistor must be at the NeoPixel end of the wire to be effective! Some products already incorporate this resistor…if you’re not sure, add one…there’s no harm in doubling up!

* Try to minimize the distance between the Arduino and first pixel.

* Try to minimize the distance between the Arduino and first pixel.