Ligne 148 : |
Ligne 148 : |
| | | |
| {{traduction}} | | {{traduction}} |
− | * Connect Pi 5V power to the power rail of the breadboard. From the power rail connect one outer lead of the potentiometer, LCD pin 2 (VDD), and LCD pin 15 (LED+). | + | * Connectez le +5V de votre RaspberryPi sur le rail d'alimentation du breadboard. Depuis le rail d'alimentation, connectez un fil: |
− | * Connect Pi ground to the ground rail of the breadboard. From the ground rail connect the other outer lead of the potentiometer, LCD pin 1 (VSS), and LCD pin 5 (R/W). | + | ** vers une des broches externes du potentiomètre, |
− | * Connect the middle lead of the potentiometer to LCD pin 3 (V0/contrast). | + | ** Le broche 2 (VDD) du LCD, |
− | * Connect Pi pin 27 (or 21 on older revision Pi's) to LCD pin 4 (RS). | + | ** la broche 15 (LED+) du LCD. |
− | * Connect Pi pin 22 to LCD pin 6 (E/clock enable). | + | * Connectez la masse/GND du Raspberry-Pi sur le rail de masse/gnd du breadboard. Depuis le rail de masse, connectez un fil:: |
− | * Connect Pi pin 25 to LCD pin 11 (DB4). | + | ** Sur l'autre broche externe du potentiomètre ('''la broche centrale du potentiomètre doit rester libre'''). |
− | * Connect Pi pin 24 to LCD pin 12 (DB5). | + | ** La broche 1 (VSS) du LCD, |
− | * Connect Pi pin 23 to LCD pin 13 (DB6). | + | ** La broche 5 (R/W) du LCD. |
− | * Connect Pi pin 18 to LCD pin 14 (DB7). | + | * Connectez la broche du milieu du potentiomètre sur la broche 3 (V0/contrast) du LCD. |
− | * Connect Pi pin 4 to LCD pin 16 (-R/red). | + | * Connectez la broche 27 du Raspberry-Pi sur la broche 4 (RS) du LCD. |
− | * Connect Pi pin 17 to LCD pin 17 (-G/green). | + | * Connectez la broche 22 du Raspberry-Pi sur la broche 6 (E/clock enable) du LCD. |
− | * Connect Pi pin 7 / CE1 to LCD pin 18 (-B/blue). | + | * Connectez la broche 25 du Raspberry-Pi sur la broche 11 (DB4) du LCD. |
| + | * Connectez la broche 24 du Raspberry-Pi sur la broche 12 (DB5) du LCD. |
| + | * Connectez la broche 23 du Raspberry-Pi sur la broche 13 (DB6) du LCD. |
| + | * Connectez la broche 18 du Raspberry-Pi sur la broche 14 (DB7) du LCD. |
| + | * Connectez la broche 4 du Raspberry-Pi sur la broche 16 (-R/red) du LCD. |
| + | * Connectez la broche 17 du Raspberry-Pi sur la broche 17 (-G/green) du LCD. |
| + | * Connectez la broche 7 / CE1 du Raspberry-Pi sur la broche 18 (-B/blue) du LCD. |
| | | |
| N'oubliez pas de raccorder le potentiomètre de réglage du contraste comme suit: | | N'oubliez pas de raccorder le potentiomètre de réglage du contraste comme suit: |