| Ligne 41 : |
Ligne 41 : |
| | </syntaxhighlight> | | </syntaxhighlight> |
| | | | |
| − | Now rebuild the ESP8266 MicroPython firmware. From inside the VM's '''~/micropython/esp8266''' folder run:
| + | Maintenant, recompilez votre firmware MicroPython pour ESP8266. Exécutez la commande suivante depuis le répertoire '''~/micropython/esp8266''' de votre machine virtuelle: |
| | | | |
| | <nowiki>make</nowiki> | | <nowiki>make</nowiki> |
| | | | |
| − | Notice in the output the '''MPY modules/test.py''' line, this shows the '''test.py''' module was picked up by the build and frozen into bytecode:
| + | Notez la ligne '''MPY modules/test.py''' dans les messages de compilation. Cela indique que le module '''test.py''' a été sélectionné par la compilation et gelé en bytecode: |
| | | | |
| | {{ADFImage|FEATHER-CHARGER-MODULE-FROZEN-22.png}} | | {{ADFImage|FEATHER-CHARGER-MODULE-FROZEN-22.png}} |
| | | | |
| − | If you don't see this line for your module then try running the '''make clean''' command and then '''make''' command again.
| + | Si vous ne constatez pas cette ligne pour les modules que vous tentez de geler alors essayez d'exécuter '''make clean''' puis encore une fois '''make'''. |
| | | | |
| − | Now copy out the newly built firmware and flash it to the ESP8266. Remember you're now using a development build so debug output will be enabled and features like the WebREPL must be manually started.
| + | Vous pouvez maintenant copier et flasher le nouveau firmware fraîchement compiler sur votre ESP8266. |
| | | | |
| − | Connect to the REPL of the board with the new firmware and try using the test module's functions by running:
| + | Souvenez vous que vous utilisez une compilation de type "développement". Les messages de débogage sont donc actif et des fonctionnalités tels que le WebREPL doivent être activés manuellement. |
| | + | |
| | + | Connectez vous en REPL sur votre carte exécutant votre nouveau firmware personnalisé. Essayez les fonctions du module "test" en saisissant les commandes suivantes: |
| | | | |
| | <syntaxhighlight lang="python"> | | <syntaxhighlight lang="python"> |
| Ligne 63 : |
Ligne 65 : |
| | {{ADFImage|FEATHER-CHARGER-MODULE-FROZEN-23.png}} | | {{ADFImage|FEATHER-CHARGER-MODULE-FROZEN-23.png}} |
| | | | |
| − | You should see the module import and functions work just like if the .py file was on the filesystem! | + | Le module doit pouvoir être importé sans erreur... et l'appel des fonctions {{fname|add()}} et {{fname|substract()}} You should see the module import and functions work just like if the .py file was on the filesystem! |
| | | | |
| | You can also freeze Python packages inside the '''modules''' folder. Just create a directory for each package and put inside it an '''__init__.py''' and other source files for the package. | | You can also freeze Python packages inside the '''modules''' folder. Just create a directory for each package and put inside it an '''__init__.py''' and other source files for the package. |