Ligne 5 : |
Ligne 5 : |
| | | |
| Vous trouverez le [http://df.mchobby.be/MODULE-GSM-HAMGSM133/8100-TDG133.pdf manuel en anglais ici]. | | Vous trouverez le [http://df.mchobby.be/MODULE-GSM-HAMGSM133/8100-TDG133.pdf manuel en anglais ici]. |
| + | |
| + | == Démarrage == |
| + | You must fi rst obtain a valid SIM Card from a GSM network provider. Use a common |
| + | mobile phone to disable the SIM Card PIN. To do so, check the manual of the mobile. |
| + | If the SIM Card PIN is not disabled, the device cannot work as it cannot connect |
| + | to the GSM network. |
| + | Before feeding the TDG133, please insert the SIM Card into the SIM Card holder (mind |
| + | the orientation) making sure it is correctly blocked, then connect the antenna cable to |
| + | the connector. Now connect the power supply. |
| + | |
| + | == Configuration == |
| + | The device can be set as follows: |
| + | * Configuration '''FACILE''' (Configuration through call) |
| + | * Configuration '''AVANCEE''' (Configuration through SMS) |
| + | * Configuration via LOGICIEL (Configuration via un PC. Nécessite l'achat d'un convertisseur USB-série pour dialoguer directement avec la carte). |
| + | |
| + | === Configuration FACILE === |
| + | EASY SETUP (Configuration through call made on start-up) |
| + | When the device is supplied with power, “LD5” will immediately flash at 1 Hz frequency. |
| + | The TDG133 will try to connect to the GSM network; when connected, “LD5” will briefly |
| + | flash every 2 seconds or so. After the system initialization (which may take several se- |
| + | conds), the device alternately illuminates yellow LEDs “LD3” and “LD4” to indicate the |
| + | “configuration call” on hold, which should take place within 3 minutes. If during this time |
| + | the unit receives a call, it stores the caller’s number (to which reply SMS will be sent) in |
| + | the first memory location, it turns the two LEDs off and becomes operative; otherwise, |
| + | at the end of the interval, it switches off the yellow LEDs and waits for the configuration |
| + | SMS (“PROFESSIONAL SETUP” mode). With the same phone used to make the first |
| + | setup call, it is also possible to switch the relay status. |
| + | This mode allows for simple |
| + | commands without sending SMS or using a computer. |
| + | |
| + | === Configuration AVANCEE === |
| + | Configuration through SMS executable at any time) |
| + | This mode takes full advantage of the device with operations as output switch, output |
| + | status query, inclusion of additional phone numbers to activate the relay, inclusion of |
| + | numbers for door opening function, reception of reply messages, change output signals |
| + | timing and, in general, set the TDG133 with all parameters via simple SMS. A full reset |
| + | to restore the default settings can also be made via SMS. The syntax for all available |
| + | commands can be found in Section 11 (Configuration SMS). |
| + | |
| + | === Configuration via LOGICIEL === |
| + | Computer SETUP (Configuration through PC connection) |
| + | This mode easily allows you to setup the TDG133 -with no additional cost- through a |
| + | computer (with a special software) connected via USB code FT782M (optional). Chap- |
| + | ter 13 provides all the necessary information to make the best use of this configuration |
| + | mode. |
| + | |
| + | {{ambox-info|Text=Le présent manuel ne s'attarde pas sur la configuration via logiciel et convertisseur USB Série. Vous pouvez consulter les détails concernant ce point dans [http://df.mchobby.be/MODULE-GSM-HAMGSM133/8100-TDG133.pdf le manuel d'utilisation en anglais].}} |
| | | |
| === Présentation === | | === Présentation === |