Ligne 10 : |
Ligne 10 : |
| | | |
| | | |
− | == Connecteurs normaux (pinHeader == | + | == Avec un Stacking Header == |
| {{underline|Besoin d'empiler?}} ce tutoriel se concentre sur l'utilisation d'un connecteur normal (pinHeader) pour Arduino. Ne suivez pas cette section du tutoriel {{pl||si vous comptez utiliser des Stacking Headers}}! | | {{underline|Besoin d'empiler?}} ce tutoriel se concentre sur l'utilisation d'un connecteur normal (pinHeader) pour Arduino. Ne suivez pas cette section du tutoriel {{pl||si vous comptez utiliser des Stacking Headers}}! |
| | | |
| [[Fichier:Bluefruit-LE-Shield-Assembler-10.jpg|320px]] | | [[Fichier:Bluefruit-LE-Shield-Assembler-10.jpg|320px]] |
| + | |
| + | == Branchez les connecteurs == |
| + | This step is for all Arduino and compatibles. Please note that we use the hardware SPI port (the 2x3 pins) for talking to the Bluefruit LE module. If that port is not available you'll have to jumper the SCK/MOSI/MISO pins to other pins and use 'software SPI'! |
| + | |
| + | <small>All the images here under are credited to [http://www.adafruit.com Adafruit Industries].</small> |
| + | {{asm-begin}} |
| + | |
| + | {{asm-row|img=Bluefruit-LE-Shield-Assembler-20.jpg}} |
| + | {{asm-text}} Begin by breaking the 36-pin male header into four pieces: one 10-pin, two 8-pin and one 6-pin. Stick the header into the Arduino sockets with the long pins down. |
| + | |
| + | Also place the 2x3 female socket header into the ICSP header on the right of the board |
| + | {{asm-row|img=Bluefruit-LE-Shield-Assembler-21.jpg}} |
| + | {{asm-text}} Place the shield on top so that all the little pins stick out through the matching holes in the shield. It should match up perfectly! |
| + | {{asm-row|img=Bluefruit-LE-Shield-Assembler-22.jpg}} |
| + | {{asm-text}} Solder in all the header on the top strips |
| + | {{asm-row|img=Bluefruit-LE-Shield-Assembler-23.jpg}} |
| + | {{asm-text}} Don't forget the 6-pin socket! |
| + | {{asm-row|img=Bluefruit-LE-Shield-Assembler-24.jpg}} |
| + | {{asm-text}} Check your solder points, all look good? You can proceed to the next steps |
| + | |
| + | {{asm-end}} |
| + | |
| | | |
| {{Bluefruit-LE-Shield-TRAILER}} | | {{Bluefruit-LE-Shield-TRAILER}} |