32 908
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 65 :
Ligne 65 : + + + Ligne 73 :
Ligne 76 : − {{tmbox | type = speedy | text = Charging current should not exceed 0.5*C. So for a 1200mAh Lipo, charging current should stay below 0.5*1200mA = 600mA}}
→Battery
{{asm-img|img=ENG-CANSAT-V2-PINOUT-Charger-R2.jpg}}
{{asm-img|img=ENG-CANSAT-V2-PINOUT-Charger-R2.jpg}}
{{asm-text}} Default Lipo charge rate is 250mA but can be tuned by replacing the R_PROG resistor.
{{asm-text}} Default Lipo charge rate is 250mA but can be tuned by replacing the R_PROG resistor.
{{tmbox | type = speedy | text = Charging current should not exceed 0.5*C. So for a 1200mAh Lipo, charging current should stay below 0.5*1200mA = 600mA}}
# Cut the 5.1K Ohms trace on the other side of the board (under the R_PROG).
# Cut the 5.1K Ohms trace on the other side of the board (under the R_PROG).
# Solder the replacement resistor in R_PROG
# Solder the replacement resistor in R_PROG
1.0K = 1000mA
1.0K = 1000mA
{{asm-end}}
{{asm-end}}
{{ENG-CANSAT-PICO-TRAILER}}
{{ENG-CANSAT-PICO-TRAILER}}