32 908
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 35 :
Ligne 35 : − + − The kit can be used either with a PowerBoost 500 Charger, either a PowerBoost 1000 Charger. − The soldering operation depends on the selected PowerBoost model.+ − − [[fichier:ENG-CANSAT-PICO-05b.jpg|640px]] − − === PowerBoost 500 Charger Soldering === − − The PowerBoost 500 is the default powering system of this kit. − − {{ambox-stop|text=The instructions doesn't applies to the PowerBoost 1000 charger.}} − − [[fichier:ENG-CANSAT-PICO-02.jpg|360px]] − − Let's solder it − − {{asm-begin}} − − {{asm-row|img=ENG-CANSAT-PICO-20.jpg}} − {{asm-text}} Pico up the base board with the back of the board on the desk. − − You should see Qwiic connector and the text "PowerBoost 500 Charger" written. − − {{asm-row|img=ENG-CANSAT-PICO-21.jpg}} − {{asm-text}} Place a section of 8 pins into the connector (the short part into the connector). − − {{underline|Tip:}} use a small piece a paper tape to maintain the connector right in place. − − {{asm-row|img=ENG-CANSAT-PICO-22.jpg}} − {{asm-text}} Flip over the board and solder the connector in place. − − {{asm-row|img=ENG-CANSAT-PICO-23.jpg}} − {{asm-text}} Flip the board again (to see the "PowerBoost" text). − − Slides the PowerBoost 500 on the connector, Solder it and cut-out the pin near of the board (with a diagonal cutter). − − '''WARNING: Electronic components must be visible on the breakout!''' − − {{underline|Tip:}} − * Push on the PowerBoost breakout with the nail against the connector.<br />This will flatten the breakout on the connector (and make it paralleled to the base board). − * Charge the tip of the iron with some solder. − * Tack a drop of solder on one pin to make the breakout staying right in place (no need to be perfect right now) − * Solder the other pins of the breakout − * Now solder the initial tacked pin (to have a nice & great solder join on that pin too) − − − {{asm-end}}
ENG-CANSAT-V2-ASSEMBLY (voir la source)
Version du 29 juillet 2025 à 20:47
, 29 juillet 2025 à 20:47→Lipo Booster soldering
{{asm-end}}
{{asm-end}}
== Lipo Booster soldering ==
== Assembling the base station ==
x
{{ENG-CANSAT-PICO-TRAILER}}
{{ENG-CANSAT-PICO-TRAILER}}