Modifications

* The pin 2 (middle one) to the ADC0 (GP26) analog input.

* The pin 2 (middle one) to the ADC0 (GP26) analog input.

The breakout line can be used to solder the temperature sensor, the Analog Grove connector can also be used for quick connection on the board.

The Analog Grove connector can be used for quick connection on the board. The image below show the Grove cable is connected to the ANALOG connector with the yellow cable inline with the silkscreen "gp26" (the white will be gp27). On the breadboard, from left to right, the red cable is 3V3, yellow (gp26) for the signal and black for ground. The TMP36 is place inline with the connector.

[[Fichier:ENG-CANSAT-V2-TMP36-ON-BREAKOUT-10.jpg|640px]]

[[Fichier:ENG-CANSAT-V2-TMP36-ON-BREAKOUT-10.jpg|640px]]

[[Fichier:ENG-CANSAT-V2-TMP36-ON-ANALOG-GROVE-10.jpg|560px]]

[[Fichier:ENG-CANSAT-V2-TMP36-ON-ANALOG-GROVE-10.jpg|560px]]