32 908
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 14 :
Ligne 14 : − {{traduction}} Ligne 30 :
Ligne 29 : − +
ENG-CANSAT-PICO-MISSION1-CAPTURE (voir la source)
Version du 4 novembre 2025 à 20:55
, 4 novembre 2025 à 20:55→With Cansat Kit V2
The CANSAT-BASE board of {{pl|2824|Kit Cansat Kit V2}} does already contains power regulation and the radio circuitry.
The CANSAT-BASE board of {{pl|2824|Kit Cansat Kit V2}} does already contains power regulation and the radio circuitry.
=== Wire the barometric sensor ===
=== Wire the barometric sensor ===
The CANSAT-BASE does already fits a StemmaQt/Qwiic connector. Just connect the Qwiic/StemmaQt wires between the board and the sensor.
The CANSAT-BASE does already fits a StemmaQt/Qwiic connector. Just connect the Qwiic/StemmaQt wires between the board and the sensor.
* The pin 2 (middle one) to the ADC0 (GP26) analog input.
* The pin 2 (middle one) to the ADC0 (GP26) analog input.
The Analog Grove connector can be used for quick connection on the board. The image below show the Grove cable is connected to the ANALOG connector with the yellow cable inline with the silkscreen "gp26" (the white will be gp27). On the breadboard, from left to right, the red cable is 3V3, yellow (gp26) for the signal and black for ground. The TMP36 is place inline with the connector.
The Analog Grove connector can be used for quick connection on the board. The image below show the Grove cable connected to the ANALOG connector with the yellow cable inline with the silkscreen "gp26" (the white will be gp27). On the breadboard, from left to right, the red cable is 3V3, yellow (gp26) for the signal and black for ground. The TMP36 is place inline with the connector.
[[Fichier:ENG-CANSAT-V2-TMP36-ON-BREAKOUT-10.jpg|640px]]
[[Fichier:ENG-CANSAT-V2-TMP36-ON-BREAKOUT-10.jpg|640px]]