1 905 octets ajoutés
, 10 juin 2013 à 12:11
{{ADX335-326-NAV}}
== Assembler ==
The board comes with all surface-mount components pre-soldered. The included header strip can be soldered on for convenient use on a breadboard or with 0.1" connectors. However, for applications subject to extreme accelerations, shock or vibration, locking connectors or direct soldering is advised.
{{asm-begin}}
{{asm-row|img=ADX335-326-ASM-01.jpg}}
{{asm-text}} '''Prepare the header strip:'''
Cut the strip[ to length if necessary. It will be easier to solder if you insert it into a breadboard - long pins down.
{{asm-row|img=ADX335-326-ASM-02.jpg}}
{{asm-text}} '''Add the breakout board:'''
Place the breakout board over the pins.
{{asm-row|img=ADX335-326-ASM-03.jpg}}
{{asm-text}} '''And Solder!'''
Be sure to solder all pins for reliable electrical contact.
{{asm-end}}
== Raccordements ==
=== L'alimentation ===
Connect the Power:
* Connect the GND pin to GND on the Arduino.
* Connect the VIN pin to the 5v pin on the Arduino.
* (For 3.3v microprocessors, connect the pin marked 3Vo to the 3.3v supply)
[[Fichier:ADX335-326-Wire-01.jpg]]
=== Connecter X,Y,Z ===
Connectez les sorties de signal X, Y et Z sur les entrées analogiques comme présenté ci-dessous:
[[Fichier:ADX335-326-Wire-02.jpg]]
=== Utiliser la référence de tension ===
For the best possible accuracy and precision, you can use the output of the accelerometer boards voltage regulator as the analog reference for the Arduino. Connect the 3Vo pin on the accelerometer board to the AREF pin on the Arduino.
{{ambox-stop|text=If you connect an external voltage reference to the AREF pin, you must set the analog reference to EXTERNAL before calling analogRead() (e.g. in your setup() function). Otherwise, you will short the internal reference with the external reference, possibly damaging your Arduino board. }}
[[Fichier:ADX335-326-Wire-03.jpg]]
{{ADX335-326-TRAILER}}