1 020 octets ajoutés
, 17 septembre 2013 à 05:43
{{Arduino-Robot-NAV}}
<h4>digitalWrite()</h4>
== Description ==
Classe [[Arduino Robot-Librairie#Classe_RobotControl|RobotControl]], librairie d'[[Arduino Robot-Librairie|Arduino Robot]].
Write a HIGH or a LOW value to the defined port on the robot. the ports are exposed on the robot as TinkerKit connectors.
== Syntaxe ==
Robot.digitalWrite(port, valeur)
== Paramètres ==
port: TKD0 to TKD5 (on the Control board), B_TK1 to B_TK4(on the Motor Board), or LED1 (located on the control board)
valeur: HIGH or LOW
== Résultat ==
aucun
== Exemple ==
<nowiki>#include <ArduinoRobot.h>
void setup(){
Robot.begin();
}
void loop(){
Robot.digitalWrite(TDK0, HIGH); // Turn on a Tinkerkit LED connected to TDK0
delay(1000);
Robot.digitalWrite(TK0, LOW); // Turn the LED off
delay(1000);
}</nowiki>
== Note ==
You cannot call Robot.digitalWrite() on TK0 to TK7
== Voir aussi ==
* [[RB-ARD-ROBOT-Func-beginSpeaker|beginSpeaker()]]
* [[RB-ARD-ROBOT-Func-beginLCD|beginLCD()]]
{{Arduino-Robot-TRAILER}}