Ligne 23 : |
Ligne 23 : |
| Vous pouvez rendre ce shield plug-and-play avec les Mega/Leonardo avec peu d'efforts. | | Vous pouvez rendre ce shield plug-and-play avec les Mega/Leonardo avec peu d'efforts. |
| | | |
− | Chercher la zone avec les 6 cavalier/pastilles en bas du shield. Trois d'entre eux sont ouvert et les trois autres fermés. | + | Chercher la zone avec les 6 cavaliers/pastilles en bas du shield. Trois d'entre eux sont ouvert et les trois autres fermés. |
| | | |
− | Solder close the three ICSP jumpers.
| + | '''Commencez''' par souder les 3 cavaliers/pastilles ICSP. |
| | | |
| {{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-03.jpg|640px}} | | {{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-03.jpg|640px}} |
| | | |
− | You can then cut the small line in between the #11, #12, #13 pads. This will free up digital #11, 12, and 13 for you to use on the Leo or Mega.
| + | '''Ensuite''', vous pouvez couper les 3 petites pistes entre les cavaliers/pastilles #11, #12, #13 pads. Cela libèrera les broches digitales #11, 12 et 13 que vous pourrez utiliser sur un Leo ou Mega. |
| | | |
− | That's it! No software or firmware hacking other than that is required.
| + | Voila, c'est fait! Pas besoin de faire une correction logicielle ou mise-à-jour du Firmware... c'est tout ce qu'il faut faire pour rendre ce shield compatible avec votre Léonardo ou Mega. |
| | | |
| {{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-04.jpg|640px}} | | {{ADFImage|TFT-TOUCH-SHIELD-v2-Connecter-04.jpg|640px}} |
| | | |
− | With this mod, the shield uses the ICSP header for data so make sure your duino (or stack of shields) has a ICSP plugged into the socket as above!
| + | Grâce a cette astuce, le shield utilise le connecteur ICSP pour l'envoi des données avec votre Arduino (ou shield déjà empilé) puisque la fiche ICSP s'enfiche sur le connecteur juste en dessous! |
| | | |
| {{TFT-TOUCH-SHIELD-v2-TRAILER}} | | {{TFT-TOUCH-SHIELD-v2-TRAILER}} |