29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 42 :
Ligne 42 : + + + + + + + + +
→Les boutons
* Hold down the SETUP button, tap on the RESET button and wait for '''6-10 seconds''' to enter '''Factory Reset Safe Mode''' mode, where the RGB LED will be flashing Green. Release the SETUP button. In this mode the Photon is reprogrammed with the software that was installed on the Photon in the factory (the Tinker application). The LED should turn white for three seconds and begin flashing quickly; when the LED switches to another color the Photon has been reset. This is useful if you encounter bugs with your firmware, or if you just want to get back to Tinker. Wi-Fi credentials are not erased in this mode.
* Hold down the SETUP button, tap on the RESET button and wait for '''6-10 seconds''' to enter '''Factory Reset Safe Mode''' mode, where the RGB LED will be flashing Green. Release the SETUP button. In this mode the Photon is reprogrammed with the software that was installed on the Photon in the factory (the Tinker application). The LED should turn white for three seconds and begin flashing quickly; when the LED switches to another color the Photon has been reset. This is useful if you encounter bugs with your firmware, or if you just want to get back to Tinker. Wi-Fi credentials are not erased in this mode.
*Hold down the SETUP button, tap once on the RESET button and wait for '''10 seconds+''' to do a '''Factory Reset''', where the RGB LED will be flashing White. Release the SETUP button. In this mode the Photon is reprogrammed with the software that was installed on the Photon in the factory (the Tinker application). The LED should turn white for three seconds and begin flashing quickly; when the LED switches to another color the Photon has been reset. This is useful if you encounter bugs with your firmware, or if you just want to get back to Tinker. Wi-Fi credentials are also erased in this mode, so you'll have to set those up again.
*Hold down the SETUP button, tap once on the RESET button and wait for '''10 seconds+''' to do a '''Factory Reset''', where the RGB LED will be flashing White. Release the SETUP button. In this mode the Photon is reprogrammed with the software that was installed on the Photon in the factory (the Tinker application). The LED should turn white for three seconds and begin flashing quickly; when the LED switches to another color the Photon has been reset. This is useful if you encounter bugs with your firmware, or if you just want to get back to Tinker. Wi-Fi credentials are also erased in this mode, so you'll have to set those up again.
== Les LEDs ==
There are two LEDs on the Photon. The big fat one in the middle is a full-color RGB LED that shows you the status of the Photon's internet connection. The other small blue LED is the user LED; it's hooked up to D7, so when you turn the D7 pin {{fname|HIGH}} or {{fname|LOW}}, it turns on and off, respectively.
{{SPARKImage|Spark-Photon-Tour-03.jpg|480px}}
The RGB LED could show the following states:
{{Spark-Photon-Materiel-TRAILER}}
{{Spark-Photon-Materiel-TRAILER}}