29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 60 :
Ligne 60 : + + + + + + + + + + + + + +
aucun résumé de modification
[[Fichier:ADF-ADJ-BBALIM-SOUDER-12.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-12.jpg]]
Tape or hold the switch in place while you solder all three pins.
[[Fichier:ADF-ADJ-BBALIM-SOUDER-13.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-13.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-14.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-14.jpg]]
We're going to solder one of the 1.0K resistors in next. The resistors should be bent over 180 like shown. Note that resistors are 'non-polarized' so you can put them in 'either way' - they work the same forwards or backwards.
[[Fichier:ADF-ADJ-BBALIM-SOUDER-15.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-15.jpg]]
Place one of the 1.0K resistors (Brown Black Red Gold) into the slot marked R1. Then place right next to it one of the 0.1uF ceramic capacitors (they're small and yellow). The resistors and ceramic capacitors are non-polarized so they can go in 'either way'
The resistor sets the brightness of the 'high voltage' indicator LED. The 0.1uF capacitor provides high frequency filtration to make the power supply cleaner.
Bend the leads out so that the parts don't fall out when you flip over the board
[[Fichier:ADF-ADJ-BBALIM-SOUDER-16.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-16.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-17.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-17.jpg]]
Solder in the two components
[[Fichier:ADF-ADJ-BBALIM-SOUDER-18.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-18.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-19.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-19.jpg]]
Then clip the long leads off.
[[Fichier:ADF-ADJ-BBALIM-SOUDER-20.jpg]]
[[Fichier:ADF-ADJ-BBALIM-SOUDER-20.jpg]]