29 910
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 404 :
Ligne 404 : − + − + + + + + + +
ENG-CANSAT-MISSION1-CAPTURE (voir la source)
Version du 29 octobre 2018 à 23:06
, 29 octobre 2018 à 23:06→Fault tolerant design
The code of the Emitter (this section) and Receiver (next section) are doing the job.
The code of the Emitter (this section) and Receiver (next section) are doing the job.
However, what would happens to your data if the antenna did break!
However, what would happens to your data if the antenna did break? All the data are lots!
This is where the
This is where the "Extra Flash" would be a great help!
As showed earlier, it is also possible to store/save the data into the Flash.
A good approach would be:
# to save the data in the Flash
# then send it over Radio.
In this way, the data stays available inside the CanSat and could be extracted as suited.
{{ENG-CANSAT-TRAILER}}
{{ENG-CANSAT-TRAILER}}