29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Afficheur LCD-part 2-Code Arduino (voir la source)
Version du 1 janvier 2013 à 20:54
, 1 janvier 2013 à 20:54Page créée avec « {{afficheur-lcd-part2-nav}} The sketch for this is based on that of lesson 11. Load it up onto your Arduino and you should find that warming the temperature sensor by puttin... »
{{afficheur-lcd-part2-nav}}
The sketch for this is based on that of lesson 11. Load it up onto your Arduino and you should find that warming the temperature sensor by putting your finger on it will increase the temperature reading.
Also if you wave your hand over the photocell blocking out some of the light, the reading will decrease.
<nowiki>
/*
Adafruit Arduino - Lesson 12. Light and Temperature
*/
#include <LiquidCrystal.h>
int tempPin = 0;
int lightPin = 1;
// BS E D4 D5 D6 D7
LiquidCrystal lcd(7, 8, 9, 10, 11, 12);
void setup()
{
lcd.begin(16, 2);
}
void loop()
{
// Display Temperature in C
int tempReading = analogRead(tempPin);
float tempVolts = tempReading * 5.0 / 1024.0;
float tempC = (tempVolts - 0.5) * 100.0;
float tempF = tempC * 9.0 / 5.0 + 32.0;
// ----------------
lcd.print("Temp F ");
lcd.setCursor(6, 0);
lcd.print(tempF);
// Display Light on second row
int lightReading = analogRead(lightPin);
lcd.setCursor(0, 1);
// ----------------
lcd.print("Light ");
lcd.setCursor(6, 1);
lcd.print(lightReading);
delay(500);
}
</nowiki>
<small>Créer par [http://learn.adafruit.com/users/srmonk Simon Monk] pour AdaFruit</small>
{{ADF-Accord}}
{{MCH-Accord}}
The sketch for this is based on that of lesson 11. Load it up onto your Arduino and you should find that warming the temperature sensor by putting your finger on it will increase the temperature reading.
Also if you wave your hand over the photocell blocking out some of the light, the reading will decrease.
<nowiki>
/*
Adafruit Arduino - Lesson 12. Light and Temperature
*/
#include <LiquidCrystal.h>
int tempPin = 0;
int lightPin = 1;
// BS E D4 D5 D6 D7
LiquidCrystal lcd(7, 8, 9, 10, 11, 12);
void setup()
{
lcd.begin(16, 2);
}
void loop()
{
// Display Temperature in C
int tempReading = analogRead(tempPin);
float tempVolts = tempReading * 5.0 / 1024.0;
float tempC = (tempVolts - 0.5) * 100.0;
float tempF = tempC * 9.0 / 5.0 + 32.0;
// ----------------
lcd.print("Temp F ");
lcd.setCursor(6, 0);
lcd.print(tempF);
// Display Light on second row
int lightReading = analogRead(lightPin);
lcd.setCursor(0, 1);
// ----------------
lcd.print("Light ");
lcd.setCursor(6, 1);
lcd.print(lightReading);
delay(500);
}
</nowiki>
<small>Créer par [http://learn.adafruit.com/users/srmonk Simon Monk] pour AdaFruit</small>
{{ADF-Accord}}
{{MCH-Accord}}