Ligne 71 : |
Ligne 71 : |
| | | |
| === ESP8266-DEV (only) === | | === ESP8266-DEV (only) === |
− | Il est possible de programmer un module {{pl|667|ESP8266-DEV}} en utilisant un {{pl|144|câble console (USB-Série-TTL)}} exploitant des signaux en logique 3.3V .
| + | You can flash a {{pl|667|ESP8266-DEV}} module by using a {{pl|144|console cable (USB-Série-TTL)}} using 3V logic for RX/TX . |
| | | |
− | Voici comment effectuer le raccordement.
| + | Here how to wire the board. |
| | | |
| [[Fichier:OLI-ESP8266-DEV-Wiring.jpg|453px]] | | [[Fichier:OLI-ESP8266-DEV-Wiring.jpg|453px]] |
| | | |
− | Pour activer le FlashMode sur un {{pl|667|ESP8266-DEV}} (version Olimex):
| + | To activates the Flash Mode on the {{pl|667|ESP8266-DEV}} (from Olimex): |
− | * Il faut presser le bouton GPIO 0 (le petit bouton bouton utilisateur présent sur l'ESP8266-DEV, qui est également branché sur le GPIO 0) | + | * Press the GPIO 0 button (the small user button on the board is wired to GPIO 0) |
− | * Puis mettre le module sous tension | + | * Then power-up the module. |
− | * Enfin relâcher le bouton GPIO 0. | + | * Release the GPIO 0 button. |
| + | |
| + | Voila, the ESP8266-DEV is set to Flash mode. |
| | | |
| === ESP8266-EVB (evaluation board) === | | === ESP8266-EVB (evaluation board) === |