Modifications
Sauter à la navigation
Sauter à la recherche
← Modification précédente
Modification suivante →
ENG-CANSAT-PICO-MISSION1-CAPTURE
(voir la source)
Version du 6 mars 2022 à 00:43
635 octets ajoutés
,
6 mars 2022 à 00:43
→Wiring on a Pico
Ligne 58 :
Ligne 58 :
| 3V3
| 3V3
|}
|}
+
+
== Wiring on Kit Cansat for Pico ==
+
+
=== Wire the barometric sensor ===
+
The BMP280 is wired to the Pico (I2C bus) via the Qwiic connector
+
+
xxx
+
+
+
=== Wire the temperature sensor ===
+
Then connect the TMP36 sensor as follows:
+
* The pin 1 (on the left) to a power source (3.3V),
+
* The pin 3 (the the right) to the ground/GND.
+
* The pin 2 (middle one) to the ADC0 analog input.
+
+
The Pico pad on the board are large enough to quickly solder the TMP36 on the board. The TMP36 can also bee soldered under the board.
+
+
[[Fichier:ENG-CANSAT-PICO-TMP36-10.png|320px]]
+
+
=== Wire the radio module ===
+
Finally wire the RFM69HCW radio as follows:
+
{{ENG-CANSAT-PICO-TRAILER}}
{{ENG-CANSAT-PICO-TRAILER}}
Admin
Bureaucrates
,
Administrateurs
29 917
modifications
Menu de navigation
Outils personnels
Se connecter
Espaces de noms
Page
Discussion
Variantes
Affichages
Lire
Voir le texte source
Voir l’historique
Plus
Rechercher
Navigation
ARDUINO
RASPBERRY-PI
[:: PI Hacking ::]
Particle.IO
Micro Python
Imprimante 3D
Actualités
Modifications récentes
Page au hasard
Aide
Outils
Pages spéciales
Version imprimable