29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 54 :
Ligne 54 : + + + + − + + + + + + + + + + + + + + + +
→PowerBoost 500 Charger Soldering
The PowerBoost 500 is the default powering system of this kit.
The PowerBoost 500 is the default powering system of this kit.
{{ambox-stop|text=The instructions doesn't applies to the PowerBoost 1000.}}
{{traduction}}
{{traduction}}
[[fichier:ENG-CANSAT-PICO-02.jpg|360px]]
[[fichier:ENG-CANSAT-PICO-02.jpg|360px]]
Let's solder it
{{asm-begin}}
{{asm-begin}}
{{asm-row|img=ENG-CANSAT-PICO-20.jpg}}
{{asm-row|img=ENG-CANSAT-PICO-20.jpg}}
{{asm-text}}
{{asm-text}} Pico up the base board with the back of the board on the desk.
You should see Qwiic connector and the text "PowerBoost 500 Charger" written.
{{asm-row|img=ENG-CANSAT-PICO-21.jpg}}
{{asm-text}} Place a section of 8 pins into the connector (the short part into the connector).
{{underline|text=use a small piece a paper tape to maintain the connector right in place.
{{asm-row|img=ENG-CANSAT-PICO-22.jpg}}
{{asm-text}} Flip over the board and solder the connector in place.
{{asm-row|img=ENG-CANSAT-PICO-23.jpg}}
{{asm-text}} Replace the board on the desk to see the "PowerBoost" text.
Slides the PowerBoost 500 as
{{asm-end}}
{{asm-end}}