Ligne 1 : |
Ligne 1 : |
| {{Tilt-Ball-NAV}} | | {{Tilt-Ball-NAV}} |
| | | |
− | xxxx
| + | Testing your sensor is simple. Put your multimeter into continuity-test mode and touch the probes to the two leads. Then tilt to determine the angle at which the switch opens and closes. |
| + | |
| + | [[Fichier:Tilt-Ball-TEST-01.jpg|500px]] |
| + | |
| + | When pointing down, the switch is Open Loop (''pas de continuité''). |
| + | |
| + | [[Fichier:Tilt-Ball-TEST-02.jpg|500px]] |
| + | |
| + | |
| + | When pointing up, the switch is closed (low resistance / continuous). |
| | | |
| {{Tilt-Ball-TRAILER}} | | {{Tilt-Ball-TRAILER}} |