Modifications

== Les tests ==

== Les tests ==

Ensure you have made all the connections noted in the Fritzing diagram on the Overview page.

{{bloc-etroit|text=Ensure you have made all the connections noted in the Fritzing diagram on the Overview page.

Program the Trinket out of the circuit, then place in the headers on the circuit board. I recommend using headers over soldering directly in due to the connections to Pin 3.

Program the Trinket out of the circuit, then place in the headers on the circuit board. I recommend using headers over soldering directly in due to the connections to Pin 3.

Power up the circuit. The battery should probably charge with the CHRG light lit on the LiPo charger circuit board. The Trinket green LED should be lit. If not, unplug and check your connections.

Power up the circuit. The battery should probably charge with the CHRG light lit on the LiPo charger circuit board. The Trinket green LED should be lit. If not, unplug and check your connections.

When working right, the red LED on Trinket is probably blinking showing the sensors that are tripped - this is normal as the PIR sensor probably sees you moving and you might not have the magnets against the mag sensors. Place the magnets next to the mag sensors and aim the PIR away from you. The system should "set up" (no blinking). Then when you move in front of the sensor it should blink once a second or so with more blinks depending on which sensors tripped as follows:

When working right, the red LED on Trinket is probably blinking showing the sensors that are tripped - this is normal as the PIR sensor probably sees you moving and you might not have the magnets against the mag sensors. Place the magnets next to the mag sensors and aim the PIR away from you. The system should "set up" (no blinking). Then when you move in front of the sensor it should blink once a second or so with more blinks depending on which sensors tripped as follows:}}

 

* No blinks - secure

* No blinks - secure

Open your terminal window and set it to work on a Serial stream. Set your serial port (Windows COMxx where xx is the number of the port you found in Control Panel earlier). The baud rate is 9600. When you press the Open button, a black terminal screen should be displayed with white text output from the Bluetooth serial stream.  

Open your terminal window and set it to work on a Serial stream. Set your serial port (Windows COMxx where xx is the number of the port you found in Control Panel earlier). The baud rate is 9600. When you press the Open button, a black terminal screen should be displayed with white text output from the Bluetooth serial stream.  

{{ADF-Image|Trinket-Alarme-Tester-01.jpg|640px}}

{{ADFImage|Trinket-Alarme-Tester-01.jpg|640px}}

== Dépannage ==

== Dépannage ==