Senseur PIR
Introduction
Les senseurs PIR sont utilisés par les robots/animaux humanoides pour effectuer la détection de mouvement. La distance de détection peut aller jusqu'à 6 à 7 mètres. Le senseur PIR est typiquement le type de technologie utilisée pour la détection de mouvement mis en oeuvre dans les systèmes d'alarme.
Les applications d'un senseur PIR sont multiples:
- Détection de mouvement et activation d'une oeuvre interactive.
- Détection de passage/intrusion.
- Commande d'une chatière automatisée.
- Détecteur pour commande d'installation domotique.
Montage
Il est vraiment facile de connecter un senseur PIR sur un microcontrôleur. Le PIR dispose d'une sortie digitale (ON/OFF HIHG/LOW), il suffit donc d'écouter la sortie digitale à l'aide d'une entrée du microcontrôleur. Il suffit détecter la montée du potentiel vers HIGH (détection du PIR) ou descente du potentiel vers LOW (non détection du PIR).
Its likely that you'll want reriggering, so be sure to put the jumper in the H position!
Power the PIR with 5V and connect ground to ground. Then connect the output to a digital pin. In this example we'll use pin 2.
Code
The code is very simple, and is basically just keeps track of whether the input to pin 2 is high or low. It also tracks the state of the pin, so that it prints out a message when motion has started and stopped.
/* * PIR sensor tester */ int ledPin = 13; // choose the pin for the LED int inputPin = 2; // choose the input pin (for PIR sensor) int pirState = LOW; // we start, assuming no motion detected int val = 0; // variable for reading the pin status void setup() { pinMode(ledPin, OUTPUT); // declare LED as output pinMode(inputPin, INPUT); // declare sensor as input Serial.begin(9600); } void loop(){ val = digitalRead(inputPin); // read input value if (val == HIGH) { // check if the input is HIGH digitalWrite(ledPin, HIGH); // turn LED ON if (pirState == LOW) { // we have just turned on Serial.println("Motion detected!"); // We only want to print on the output change, not state pirState = HIGH; } } else { digitalWrite(ledPin, LOW); // turn LED OFF if (pirState == HIGH){ // we have just turned of Serial.println("Motion ended!"); // We only want to print on the output change, not state pirState = LOW; } } }
Notes
Don't forget that there are some times when you don't need a microcontroller. A PIR sensor can be connected to a relay (perhaps with a transistor buffer) without a micro!
Où Acheter
Traduit avec l'autorisation d'AdaFruit Industries - Translated with the permission from Adafruit Industries - www.adafruit.com
{MCH-Accord}}