RASP-SENSE-HAT-ASTRO-PI-Logiciel
Préambule
Ce guide part du principe que vous diposez déjà d'une carte SD avec Noobs ou Raspbian. Si ce n'est pas le cas, vous pouvez télécharger Noobs ou Raspbian depuis la section "Téléchargement" du site Raspberry-Pi (download en anglais).
Voyez également le guide d'installation de NOOBS (anglais) sur le site de la fondation Raspberry-Pi.
Branchez votre Sense Hat sur le Raspberry-Pi puis démarrez le.
Installation des pilotes
Ensure your Pi is connected to the internet, then run the following command (from the command prompt or a Terminal window) to download and start the Astro Pi installation script:
wget -O - http://www.raspberrypi.org/files/astro-pi/astro-pi-install.sh --no-check-certificate | bash
This will take about 5 minutes on a Pi 2 and about 15 to 20 minutes on a Pi 1. When it's finished you'll see the following message:
You must reboot to complete the Astro Pi installation Type: sudo reboot and press Enter when ready
Reboot the Raspberry Pi to complete the installation:
sudo reboot
The rainbow pattern on the LED matrix should now turn off during boot up.
Ensuite
Maintenant que nous sommes prêt, nous allons écrire notre premier programme pour la carte Sense Hat.
Source: Getting Started with Astro PI et Astro-Pi Guide proposé par Raspberry Pi Learning Resource (www.raspberrypi.org)
Licence Creative Commons - CC-BY-SA
The learning resource is provided for free by the Raspberry Pi Foundation under a Creative Commons licence.
Find more at raspberrypi.org/resources and github.com/raspberrypilearning.
Crédit de traduction: Toute référence, mention ou extrait de cette traduction doit également être explicitement accompagné du crédit de traduction suivant : « Traduction par MCHobby (shop.MCHobby.be) » avec un lien vers la source (donc cette page) et ce quelque soit le média utilisé.