Modifications

Sauter à la navigation Sauter à la recherche
1 252 octets ajoutés ,  27 novembre 2015 à 11:45
Page créée avec « {{ADAFRUIT-FONA-NAV}} {{traduction}} == Brancher sur USB == If you have a USB console cable you can wire it up directly and send commands using any Terminal software Fo... »
{{ADAFRUIT-FONA-NAV}}

{{traduction}}

== Brancher sur USB ==
If you have a USB console cable you can wire it up directly and send commands using any Terminal software

For Windows, [http://www.putty.org/ we suggest Putty] - it's free and open source!

== Raccorder ==
In this example, we're using {{pl|144|le câble console que nous proposons}}.

{{ADFImage|ADAFRUIT-FONA-Brancher-USB-00.jpg|480px}}

You will have to install the PL2303 driver and determine the COM port before you continue.

{{ADFImage|ADAFRUIT-FONA-Brancher-USB-02.png|480px}}

Connect to that COM port at 8N1 (8-bit, no parity bit, 1 stop bit) at 9600 baud. You can actually use any baud rate and it will autodetect but 9600 is supported by any terminal program!

{{ADFImage|ADAFRUIT-FONA-Brancher-USB-03.png|480px}}

=== Vérifiez bien! ===
* You have a Lipoly battery plugged in to the FONA JST
* You have a working 2G SIM installed in the back
* Connect Black wire to GND
* Connect White wire to TX
* Connect Green wire to RX
* Connect Red wire to Vio
* You may need to hold down the KEY button for 2 seconds until the PWR LED is lit and the NET LED blinks

{{ADFImage|ADAFRUIT-FONA-Brancher-USB-04.jpg|480px}}

== Commandes de test ==
{{traduction}}

{{ADAFRUIT-FONA-TRAILER}}
32 920

modifications

Menu de navigation