Modifications

Sauter à la navigation Sauter à la recherche
Ligne 46 : Ligne 46 :  
Nos composants sont connectés et nous sommes prêt à les monter dans le boîtier.
 
Nos composants sont connectés et nous sommes prêt à les monter dans le boîtier.
   −
== Test Components ==
+
== Tester les composants ==
−
<p class="p2">Its good practice to test all of our components before we start mounting things to the enclosure. Just as a sanity check, this ensures our components and wiring is all good and working. Go ahead and insert your microSD card into the Raspberry Pi - make sure the software is already installed and loaded.
+
C'est une très bonne pratique de tester les divers composants avant de les monter dans une boîte.  
   −
<p class="p2">Once thats sorted, plug in the JST connector from our battery into the PowerBoost 1000C. Next, plug the Pi ribbon cable into the PiTFT GPIO breakout and connect the other end to the PiGRRL Gamepad. Then, lay the PiTFT over the Raspberry Pi and press it down to connect together the GPIOs until they’re fully seated.
+
Juste une vérification de base, de quoi assurer que nos composants et raccordement sont corrects et fonctionnels.
 +
 
 +
Pour ce faire, insérez la carte microSD dans le Raspberry Pi - et assurez vous que le logiciel est correctement installé.
 +
 
 +
Une fois les éléments disposez sur une surface non conductrice, brancher l'accu dans le connecteur JST du PowerBoost 1000C.  
 +
 
 +
{{traduction}}
 +
 
 +
Next, plug the Pi ribbon cable into the PiTFT GPIO breakout and connect the other end to the PiGRRL Gamepad. Then, lay the PiTFT over the Raspberry Pi and press it down to connect together the GPIOs until they’re fully seated.
    
<p class="p2">Now you can flip the slide switch to power on the circuit. The PiTFT should display the boot up scripts and automatically launch RetroPi Emulationstation. Test out the DPad and buttons to see if everything works as expected. You should hear audio once a ROM is loaded. If you don’t have any loaded, reference the software page for uploading ROMs (You should be able to launch Quake from the Ports section).
 
<p class="p2">Now you can flip the slide switch to power on the circuit. The PiTFT should display the boot up scripts and automatically launch RetroPi Emulationstation. Test out the DPad and buttons to see if everything works as expected. You should hear audio once a ROM is loaded. If you don’t have any loaded, reference the software page for uploading ROMs (You should be able to launch Quake from the Ports section).
32 920

modifications

Menu de navigation