Modifications

Sauter à la navigation Sauter à la recherche
130 octets ajoutés ,  26 mai 2013 à 19:21
aucun résumé de modification
Ligne 25 : Ligne 25 :       −
You don't need to connect the '''ADDR''' (i2c address change) or '''INT''' (interrupt output) pins.
+
Vous n'avez pas besoin de connecter les proches '''ADDR''' (I2C address change pour ''changement d'adresse I2C'') et '''INT''' (interrupt output pour ''sortie d'interruption'').
   −
The '''ADDR''' pin can be used if you have an i2c address conflict, to change the address.
+
La broche '''ADDR''' peut être utilisé pour vous avez un conflit d'adresse I2C. Pour changer l'adresse:
−
* Connect it to ground to set the address to '''0x29''',  
+
* Connectez la à la masse (GND) pour fixer l'adresse à '''0x29''',  
−
* connect it to 3.3V (vcc) to set the address to '''0x49''' or
+
* Connectez la à 3.3V (vcc) pour fixer l'adresse à '''0x49''' ou
−
* leave it floating (unconnected) to use address '''0x39'''.
+
* laissez la flottante (non connectée) pour utiliser l'adresse '''0x39'''.
   −
The '''INT''' pin is an ouput from the sensor used when you have the sensor configured to signal when the light level has changed. We don't have that code written in this tutorial so you don't have to use it. If you do end up using it, use a 10K-100K pullup from '''INT''' to 3.3V (vcc)
+
La broche '''INT''' pin is an ouput from the sensor used when you have the sensor configured to signal when the light level has changed. We don't have that code written in this tutorial so you don't have to use it. If you do end up using it, use a 10K-100K pullup from '''INT''' to 3.3V (vcc)
    
{{TSL2561-TRAILER}}
 
{{TSL2561-TRAILER}}
32 920

modifications

Menu de navigation