Modifications

Sauter à la navigation Sauter à la recherche
1 126 octets ajoutés ,  7 novembre 2012 à 21:54
aucun résumé de modification
Ligne 178 : Ligne 178 :     
[[Fichier:ADF-ADJ-BBALIM-SOUDER-39.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-39.jpg]]
 +
 +
Next is the large electrolytic capacitor. Just like the other one, its polarized. Make sure the long lead goes into the (+) marked pad.
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-40.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-40.jpg]]
 +
 +
Finish off the 'low voltage' side by inserting the second 1.0K resistor '''R2''' and the second 0.1uF ceramic capacitor '''C4'''
 +
 +
Solder and clip all the leads
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-41.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-41.jpg]]
Ligne 186 : Ligne 192 :     
[[Fichier:ADF-ADJ-BBALIM-SOUDER-43.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-43.jpg]]
 +
 +
Lets take another break and quickly test what we've done so far.
 +
 +
Remove the PCB from the vise and clear off the tape from wire bits. Then plug in your DC power supply again
 +
 +
Switch the kit ON and switch the voltage selection switch from 3V to 5V to Adj. The red LED should change in brightness. It should be dim at 3V, brighter at 5V and brightest at Adj. (we haven't put in the adjusting potentiometer yet)
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-44.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-44.jpg]]
Ligne 192 : Ligne 204 :     
[[Fichier:ADF-ADJ-BBALIM-SOUDER-46.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-46.jpg]]
 +
 +
Lets finish up this kit!
 +
 +
Place the 100K trim potentiometer in the middle. This is what lets us adjust the voltage output from 1.25V to 20V
 +
 +
The trimmer sits above the PCB a bit, this is OK.
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-47.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-47.jpg]]
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-48.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-48.jpg]]
 +
 +
Next we will solder in the 2-pin terminal jack. This lets us connect up wires to power the board from a battery or similar.
 +
 +
Make sure that the 'holes' of the terminal block are facing out so that you can plug wires in!
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-49.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-49.jpg]]
Ligne 202 : Ligne 224 :     
[[Fichier:ADF-ADJ-BBALIM-SOUDER-51.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-51.jpg]]
 +
 +
xxx
    
[[Fichier:ADF-ADJ-BBALIM-SOUDER-52.jpg]]
 
[[Fichier:ADF-ADJ-BBALIM-SOUDER-52.jpg]]
29 917

modifications

Menu de navigation