29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 8 :
Ligne 8 : + +
Adafruit Motor Shield V2-Moteur Stepper (voir la source)
Version du 19 décembre 2016 à 13:09
, 19 décembre 2016 à 13:09→Pour les moteurs unipolaires
=== Pour les moteurs unipolaires ===
=== Pour les moteurs unipolaires ===
Pour connecter un moteur unipolaire, vous devez identifier quel fils appartient à quel bobine.
For unipolar motors: to connect up the stepper, first figure out which pins connected to which coil, and which pins are the center taps. If its a 5-wire motor then there will be 1 that is the center tap for both coils. [http://learn.adafruit.com/adafruit-motor-shield/resources Theres plenty of tutorials online on how to reverse engineer the coils pinout]. The center taps should both be connected together to the GND terminal on the motor shield output block. then coil 1 should connect to one motor port (say M1 or M3) and coil 2 should connect to the other motor port (M2 or M4).
For unipolar motors: to connect up the stepper, first figure out which pins connected to which coil, and which pins are the center taps. If its a 5-wire motor then there will be 1 that is the center tap for both coils. [http://learn.adafruit.com/adafruit-motor-shield/resources Theres plenty of tutorials online on how to reverse engineer the coils pinout]. The center taps should both be connected together to the GND terminal on the motor shield output block. then coil 1 should connect to one motor port (say M1 or M3) and coil 2 should connect to the other motor port (M2 or M4).