29 917
modifications
Modifications
Sauter à la navigation
Sauter à la recherche
Ligne 1 :
Ligne 1 : + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
aucun résumé de modification
{{ENG-CANSAT-PICO-NAV}}
{{ENG-CANSAT-PICO-NAV}}
== About the TMP36 Sensor ==
The TMP36 is the reference analogue temperature sensor in the Arduino world. It is affordable, small et power efficient. For sure there are better temperature sensors but this one will do the job for almost nothing :-)
This sensor is very common and easy to use. It is also one of the components of the {{pl|11|ARDX development kit}}.
With the TMP36, it is possible to measure a temperature from -50°C to 125°C, the output voltage is proportional to the temperature.
Don't be fooled, the TMP36 looks like a transistor (eg: P2N2222AG) but it isn't a transistor. It is a complex sensor within a package identical to a transistor.
There are 3 pins on the TMP36.
* the '''ground''' (on the left),
* the '''output''' signal (center position),
* the '''+5 volts''' (on the right)
[[Fichier:TMP36-pinout.jpg|360px]]
The sensor output signal does output 10 millivolts per degree (with 500mV offset for temperature under 0°C).
Eg:
* 25° C --> output = 750 mV
* 0° C --> output = 500mV
=== Technical detail ===
* Analog output (see graphics)
* Temperature range: from -50°C to 125°C
* Power supply range: 2.7 to 5.5v
* [http://www.analog.com/en/mems-sensors/digital-temperature-sensors/tmp36/products/product.html TMP36 datasheet] (''analog.com'', html)
=== How to measure the temperature ===
It will be necessary to convert the analogue voltage intro degree. As the TMP36 can also measure negative temperature, the 0 degree Celcius is placed at 500 mV offset. So, any voltage under 0.5 Volt is a negative temperature.
[[Fichier:TMP36-Graph.png]]
Here is the formula to use with a TMP36 powered at 3.3v:
Temp in °C = ( output_voltage_in_mV - 500) / 10
So, if we do have an output voltage of exactly 1 Volt (1000 mV) then the temperature would be
temp = (1000 - 500)/10
So 50 Celcius degrees.
== Wiring ==
To use the TMP36, connect:
* The pin 1 (on the left) to a power source (3.3V),
* The pin 3 (the the right droite) to the ground/GND.
* The pin 2 (middle one) to the ADC0 analog input.
[[Fichier:ENG-CANSAT-PICO-TMP36-01.png|480px]]
The TMP36 output voltage would range from 0V @ -50°C to 1.75V @ 125°C. So no risk for our 3V based microcontroler.
== Testing the sensor ==
xxx
xxx
{{ENG-CANSAT-PICO-TRAILER}}
{{ENG-CANSAT-PICO-TRAILER}}